RMK 3D Printed Resin 1/24 American Racing Vintage Dragster Wheels (Set of 4)

3D Resin Printed by RMK! Design by DRM 64.

Scale 1/24 (approx)

Rears 34mm Diameter x 16.7mm Wide

Fronts 25mm Diameter x 7mm Wide

This set of scale wheels replicates two of the most iconic wheel designs in the history of Motorsports: The famous "American Racing" magnesium wheels, created for high performance Dragsters in the early 1960's.

Many successful pre-1966 race cars from the NHRA used a set like the ones modelled here, sporting a "TORQ-THRUST" 5 spoke 15in rim at the rear and the extremely lightweight "12 Spoke" 15in rim at front.

Rear tires modelled here are based on the classic "Pie Crust" ply-bias tire used in Drag Racing in the early 60s, just before the modern Goodyear "slicks" took the lead in tire technology.

This set of wheels will suit perfectly on almost any "Gasser" or Vintage Dragster, giving a period-correct look.

Produced using high quality UV Resin on a 3D printer and cured using UV LED lights. (Some discolouration may occur during the curing process). Rear wheels are hollow with small drain holes, some cleaning fluid may still be inside, rest on a folded paper towel till dry.

As with all resin products some clean up and putty of imperfections is required to get the best results, but pictures show the body without any post print alterations, the detail is that good! Wash all resin products in warm soapy water and give a light sand before painting.